No products found.
If you own a home with a source of water nearby it’s to your benefit to use a well pump system. Water pressure tanks help push water from an underground source into your home. After a well is built and drilled in the ground, a well tank like the Menards Pressure Tank is usually installed a bit below the water level.
This allows you to use the water in the well in your home. Installing the well tank below the water level assures that the tank will not be affected by either drought or any water drawdown. The size of the pump that is installed within the well is determined in part by the size of your home.
Menards Pressure Tank Pros & Cons
PROS
CONS
Menards Pressure Tank
Pressure Tank
The water is pumped into a water pressure tank. This tank is what creates the flow of water into your home using pressure.
Once installed these water systems can last for many years. It is important that you understand how a water system works so you know which product to chose and can troubleshoot your system should any issues arise.
Below we offer a review of the Menards pressure tank and talk about how the tanks work. This will help you on your search for the best system for your home and give you a quick snapshot view of the products available.
What Is a Menards Pressure Tank and How Does It Work?
The Menards pressure tank works by receiving the water pushed into it by the water pump, then compressing the air present within the tank until the pressure within the tank reaches a certain preset level.
When a faucet is turned in within the home, the pressure that has been created within the tank forces the water into the plumbing causing the pressure to drop back down. Once the pressure drops to a certain preset level, the water pump is triggered and turns on drawing more water into the home and the tank until the facet it shut off.
Once the faucet is off, the water will continue to flow into the tank until the preset pressure within the tank is once again reached which will shut off the water pump. This cycle will begin every time water is used within the home.
The Menards pressure tank comes in a variety of forms and styles depending on your needs. They have the standard and pre-pressurized tanks. They also have a shallow well, deep well, and submersible water tanks.
Pricing of Menards Pressure Tank
The pricing of a Menards pressure tank is determined by the size of the tank, as well as whether you purchase a standard or pre-pressurized water tank.
A pressure tank of 2-5 gallons can be under 100 dollars, while the larger tanks that fall between 20 to over 100 gallons can be well over 300 dollars. The main consideration is matching your water pressure tank size to the water demands in your home. You want to make sure that you have enough water in your home to fill your needs.
If you have a larger home or use a lot of water, it’s better to invest in a larger tank.
Here are some testimonials from users of the Menards pressure tank products so you can get a feel of what having the pressure tank looks like.
WaterWorker HT-20B Vertical Pressure Well Tank, 20-Gallon Capacity, Blue
“Tank arrived with-in 5 days after ordered. Minor dents inside and base. Reading many comments concerning dents in the tank from shipping. The MFG should insulate the sided of the shipping carton with a few sheets of Styrofoam. Not a costly item to satisfy the customer and take care of the problem.
Amazon Reviewer
The tanks come now just in a box with NO packing material. We all know that shipments of items are handled many times prior to reaching their destination. They should come free of any external defect with proper packing material. The tank is installed and works great. Great water pressure and the well pump runs less. Satisfied with the tank but MFG should read these comments and take them seriously.” –American National Standard Institute
Other Reviews
“The pressure tank was delivered quickly and after installation, it performed great. Actually a great product. I am pleased with it.
I do want to note what others have commented on as well: the base was bent. It seems to me it would be a minor issue to insert a heavier piece of carton backing on the base of the shipping box, and therefore prevent this from happening.
Of note: the bent base does not affect the performance of the unit, as it is the base of the pressure tank. However, it seems like this is a shipping issue that could easily be rectified for little to no additional packaging cost.” – Amazon Reviewer
WaterWorker HT-4B In-Line Pressure Well Tank, 4-Gallon Capacity, Blue
“I used this in an RV / Coach application if that’s not you please disregard…
This thing is great! This is one of the best things I have done, but be aware there are some limitations.
Good:
– I can turn the pump off and there is enough water stored to flush, wash hands, rinse a plate or wash some fruit…
– My pump previously needed to cycle to get a “good” flush. it’s now ready to go… ( everyone wins)!
– I can’t find a surge tank for my hot water heater on the coach, so I’m assuming this is helping all around
– You can install this anywhere on the high-pressure side ( it helps to be near the pump, but there may be a spot hiding someplace int he coach )
– Crazy easy to install! I used 1 1/2 inch “T” sharkbite connector, a length of 1/2 pex, a sharkbite 1/2 to 3/4 adapter and a 3/4 braided line. all said and done at the big orange box store I was out about forty bucks. ( cut pipe anywhere AFTER your pump put parts in place. )
note:
– They do make a vibration resistant soft pipe dope. I figured this was for the RV so it seemed like the right application.
– If your pipes are tight you will need to make two cuts to remove the material for your “T”
Bad (Well, not really bad, just be aware )
-This is a 2-gallon tank, it does not mean you’re getting two gallons out of this tank… (I did not expect to, but there will be someone…).
-The pump would normally cycle/purr for about 5 seconds prior to installing this. Now near the top end of the pressure ( adding water to this tank ) it now has a constant hum for 30+ seconds… not really a bad its just what it takes for my pump to fill this with 35#’s of pressure.
-Not really a bad but if your boondocking (dry camping) and you normally flush to get that little bit of toilet water down so it does not go everywhere as you drive, it now means you have about a gallon… (I turn on the sink to drain it, then flush, but you’re losing a precious resource).
Other
To strap this down I went with the 4 stainless steel hose clamps from the big orange box store (they did not have large enough ones to fit and online they were 20.00, these were .99 cents X4.) I drilled two holes and screwed them to the floor then screwed them together.
Seems to work well. The only thing I’m going to change is adding some U brackets around the pex line. I’m worried about it moving around. Forr a 1.50 I get 10 brackets…
Bottom line
Happy I did it… you will be also.” – Amazon Reviewer
How It Compares
The Menards pressure tank is made under the WaterWorks brand name. The pressure tanks from WaterWorks are usually certified and given the sign of approval from the National Sanitation Foundation, or NSF, and American National Standard Institute, or ANSI.
The NSF is a not-for-profit organization that promotes sanitation. The ANSI is the European equivalent.
Menards pressure tanks are made with durable materials and are both efficient and flexible. There is going to be a tank that fits your needs.
Purchasing through Menards can save you some money, but you can find deals elsewhere.
What We Think
The final verdict is that the Menards pressure tank, whichever you decide on, is a good and affordable product, and when you purchase one you can do so with the assurance that you are getting a good product.
The Menards pressure tank is a great product and good for anyone who needs a pressurized water tank for their home. No matter which one you get, it’s going to be top of the line.
Finding a deal for purchasing these water tanks is easy. There are plenty of deals on sites such as Amazon or on one of the many sites that focus on finding good deals.
Below we’ve listed some deals and the appropriate links to those deals you can consider when you decide on the perfect pressure water tank for your home.
Coupons and Deals
Here is a list of a few deals available for different models of the Menards pressure tank.
20 Gallon Vertical Stand Model Pre-Charged Well Tank
Description of Features
- Polypropylene-liner is NSF certified
- The liner doesn’t impart taste or odor into water
- The diaphragm separates water from the air chamber
- The diaphragm will not fold or crease
- Galvanized tank equivalent of 42 gallons
- Precharged to 38 PSI
- 100 PSI max working pressure
- Discharge size 1″ NPTF
- Malleable iron elbow with stainless insert
- No plastic elbow to cross-thread, strip, crack
5.3 Gallon Horizontal Pre-Charge Well Tank
The WaterWorker Horizontal Pre-Charge Well Tank has a steel shell that carries water weight magnificently. The polypropylene liner included in the water reservoir prevents chipping, peeling, and cracking. It also helps prevent any smells from seeping into the water.
Features Offered
- Polypropylene-liner is NSF certified
- The liner doesn’t impart taste or odor into water
- The diaphragm separates water from the air chamber
- The diaphragm will not fold or crease
- Galvanized tank equivalent of 12 gallons
- Pre-charged to 38 PSI
- 100 PSI max working pressure
- Discharge size 3/4″ NPTF
- Malleable iron elbow with stainless insert
- No plastic elbow to cross-thread, strip, crack
WaterWorker HT-20B Vertical Pressure Well Tank, 20-Gallon Capacity, Blue
The pressure well tank has a thick diaphragm that helps prevent air loss and loss of pressure. The
diaphragm keeps the pre-charged air disconnected. The WaterWorker HT20HB has great overall quality for a good price. It is easy to install and is built with flexibility, unlike bladder tanks.
The pressure well tank is listed on the National Sanitation Foundation (NSF) and is designed to meet the requirements set by the FDA.
- Designed to meet the requirements of, and are listed by the National Sanitation Foundation (NSF) under ANSI/NSF Std 61
- The Butyl diaphragm has a seamless construction and is designed to flex rather than stretch and crease like bladder tanks
- The polypropylene liner for the water reservoir will not flake, chip, crack or peel and does not impart taste and odor to the water
- Diaphragm, liner isolate water from contact with deep drawn steel domed shell – twice as strong as rolled steel shell of the same thickness
- A high gloss enamel finish protects the tank from the elements
- Pre-charged to 25psi: please refer to the product manual for proper pre-charge setting
Summary
In this article, we’ve covered how pressure water tanks work, what the Menards pressure tank is, what WaterWorks has tried to accomplish with the product, and if their water tanks meet these expectations.
We’ve provided an extensive review of the product as well as the response of various users of the product to help with your decision-making.
We’ve offered our view and have provided you with deal options you can choose from should you decide to add this to your collection.
We are confident that this review will help you formulate your own verdict on the Menards pressure tank.
QUALITY | PRICE | RATINGS |
---|---|---|
GREAT | $$ |
No products found.
Featured Image CC2.0 wdherron via Fickr logo, text and banner added.
Last update on 2024-03-29 at 07:06 / Affiliate links / Images from Amazon Product Advertising API
Leave a Reply